Mechanical Instructions - Philips DELLP1230 Service Manual

0. Location of the panel
0.1 Main panel (1160)
0.2 Video panel (1161)
1. General
To be able to perform measurements and repairs on the "circuit
boards", the monitor should be placed in Service Position (fig. 1) first:
How to remove the back cover of monitor :
There are 2 screws in the lid [1 screw are at the right side of the
monitor, The other 1 screw are at the left side of the monitor],to fix
the front cabinet and back cover of the monitor.
Step 1: To open the lid at the right-upper side and 1
downer side of the monitor.(FIG.3)
Step 2: To open the lid at the left-upper side and
downer side of the monitor.(FIG.4)
Step 3: To remove the back cover, you can see FIG.5
Step 4: To remove the13 screws on the metal shield, and remove
the metal shield, you can see FIG.6.
Chassis :
- After remove the back cover & metal shield, you can see the inside
of the monitor as Fig. 6.
- To remove 13 screws for service position as Fig. 5 to Fig. 8.
- Include remove bottom plate screw, then slide out chassis board
and disconnect metal shield.
Video panel :
- After remove the metal frame (Fig. 5), to remove the metal shield
on rear side of Video panel for measurement.
Main panel :
After remove the metal frame.
- To cut out cable tie and disconnect "video panel"
- To disconnect EHT cable
- To disconnect ground wire(1703) of video board.
- To disconnect M1311(4pin) to control panel.
- To disconnect M1501(4pin) yoke connector.
- To disconnect M1131(2pin) degaussing coil
- To slide out Main panel as Fig. 1.
Service position :
To get service position as Fig. 1 through Fig. 2 to Fig. 8.
2. Repair instructions
After the service position was obtained, all the panel's copper track
side could be accessed.
1161
1160
Fig. 1 Service Position

Mechanical Instructions

screw in right-
1screw in left-
DELL P1230 M25P
Fig. 2
screws
lids
screws
Fig. 3
Fig. 5
screw
Fig. 7
9
Go to cover page
Fig. 4
Fig. 6
Fig. 8