Table of Contents
Advertisement
Making/Answering Calls
Note:
R Calls to emergency numbers cannot be
made until key lock is turned off.
Power back-up operation
When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power back-up mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. You can program
"Power Failure" and the default setting is
"Auto" (page 26).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, "Base no
power Press
pressing M
N on the handset, place it
on the base unit to start power back-up
mode.
R Power back-up mode will not work if the
battery level of the power supplying
handset is
/
R Do not lift the power supplying handset
from the base unit during power back-up
mode.
R Do not touch the handset's charge contacts
during power back-up mode.
R If the battery level is low, the unit will not
work sufficiently during power back-up
mode. In addition, in case handset battery
power runs out, we recommend connecting
a corded-type telephone (without AC
adaptor) to the same telephone line or to
the same telephone line jack using a
T-adaptor.
R Calls cannot be made during a power
failure until key lock is turned off (page 17).
Panasonic Ni-MH battery
performance (supplied batteries)
during power back-up mode
When the batteries are fully charged,
operating time of the handset in power
back-up mode varies depending on usage.
18
" is displayed. After
.
– Continuous use of the handset in power
back-up mode: 2 hours max.
– Continuous use of the handset other than a
handset in power back-up mode: 3 hours
max.
– Not in use in power back-up mode: 3 hours
max.
Note:
R Actual battery performance depends on
usage and ambient environment.
Making calls during a power
failure
n When only 1 handset is registered:
1
Lift the handset and dial the phone
number.
2
Within 1 minute, place the handset on
the base unit.
R Wait until speakerphone is turned
on automatically and the call is
made.
3
When the other party answers the
call, keep the handset on the base
unit and talk using the speakerphone.
4
When you finish talking, press
M
N.
Note:
R In step 2, if you do not place the
handset on the base unit within 1
minute, the power back-up mode turns
off. In this case, press M
handset and dial the phone number.
Then try again from step 2.
n When 2 or more handsets are registered:
You should leave one handset on the base
unit for supplying the power, and use
another handset for making calls. For the
operation, please see "Making calls",
page 16.
Note:
R During a call with the handset placed on
the base unit (power back-up mode),
the call may be disconnected if you
touch the handset. In such case, try to
call back.
N on the
Advertisement
Table of Contents
