Table of Contents
Advertisement
Making/Answering Calls
Note:
R Calls to emergency numbers cannot be
made until key lock is turned off.
Power back-up operation
When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power back-up mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. You can program
"Power Failure" and the default setting is
"Auto" (page 26).
Important:
R If a handset is not placed on the base unit
when a power failure occurs, "Base no
power Press
pressing M
N on the handset, place it
on the base unit to start power back-up
mode.
R Power back-up mode will not work if the
battery level of the power supplying
handset is
/
.
R Do not lift the power supplying handset
from the base unit during power back-up
mode.
R Do not touch the handset's charge contacts
during power back-up mode.
R If the battery level is low, the unit will not
work sufficiently during power back-up
mode. In addition, in case handset battery
power runs out, we recommend connecting
a corded-type telephone (without AC
adaptor) to the same telephone line or to
the same telephone line jack using a
T-adaptor.
R Calls cannot be made during a power
failure until key lock is turned off (page 17).
Panasonic Ni-MH battery
performance (supplied batteries)
during power back-up mode
When the batteries are fully charged,
operating time of the handset in power
back-up mode varies depending on usage.
18
TG80xxAL_NZ(en)_1021_ver001-2.pd18
– Continuous use of the handset in power
– Continuous use of the handset other than a
– Not in use in power back-up mode: 3 hours
Note:
R Actual battery performance depends on
Making calls during a power
failure
n When only 1 handset is registered:
" is displayed. After
n When 2 or more handsets are registered:
18
back-up mode: 2 hours max.
handset in power back-up mode: 3 hours
max.
max.
usage and ambient environment.
1
Lift the handset and dial the phone
number.
2
Within 1 minute, place the handset on
the base unit.
R Wait until speakerphone is turned
on automatically and the call is
made.
3
When the other party answers the
call, keep the handset on the base
unit and talk using the speakerphone.
4
When you finish talking, press
M
N.
Note:
R In step 2, if you do not place the
handset on the base unit within 1
minute, the power back-up mode turns
off. In this case, press M
handset and dial the phone number.
Then try again from step 2.
You should leave one handset on the base
unit for supplying the power, and use
another handset for making calls. For the
operation, please see "Making calls",
page 16.
Note:
R During a call with the handset placed on
the base unit (power back-up mode),
the call may be disconnected if you
touch the handset. In such case, try to
call back.
2011/10/21
15:09:42
N on the
Advertisement
Table of Contents
