Table of Contents
Advertisement
BATTERIES
Whenever batteries need to be replaced, the
Dolphin will blink twice with every key press.
Simply replace the batteries. The Dolphin retains
your favorite settings.
INSTALLING BATTERIES
1. On the back of the Dolphin Remote, remove
the screws that hold the battery cover in place
and lift off the battery cover.
2 Obtain two (2) fully-charged AA
alkaline batteries.
Match the + and – marks on the batteries to
the + and – marks in the battery case, then
insert the new batteries.
3. Press the battery cover back into place, being
careful to align it with the rubber seal.
4. Replace the screws that hold the battery cover
by carefully starting each one without tightening
it. Once they are all started, snug up one
screw and then do the same to the screw on
the opposite side of the door. Repeat this in a
crossing pattern until all screws are snug.
Do not overtighten them. This will assure an
5. Test the unit by pressing any mode key (e.g.,
TV, VCR/DVD, CBL/SAT, RCVR, SPA, or CD).
If the batteries are inserted correctly, the LED
will blink once.
7
Advertisement
Table of Contents
