Using The Learning Feature; Programming A Learning Key - Balboa Dolphin II CE User Manual

USING THE
LEARNING FEATURE
You can program the non-spa buttons to add
devices (e.g., VCR Tracking Up or Down).
NOTE: PLEASE HAVE YOUR ORIGINAL REMOTE
CONTROLS ON HAND BEFORE PROGRAMMING
THE LEARNING FEATURE. BE SURE TO PRESS
EACH KEY WITHIN 10 SECONDS OF THE
PREVIOUS ENTRY. IF 10 SECONDS PASS BETWEEN
ENTRIES, THE REMOTE CONTROL WILL EXIT THE
PROGRAMMING MODE.

Programming A Learning Key

1. Place your original remote control (e.g., TV
remote control) at a 90˚ angle to the underside
of the Dolphin Remote (1.5" to 2" apart).
The original remote LED should point to the
area directly in between the two footings on
the underside of the Dolphin Remote. (See
illustration on next page.)
2. Press and hold SETUP until the LED (red light)
blinks twice, then release SETUP.
3. Enter 9 - 7 - 5. The LED will blink twice.
4. Press a device key once (e.g., TV) to assign a
mode for learning.
5. Press an open learning key once (e.g., Guide)
to store a feature to be learned. The LED will
blink rapidly.
NOTE: THE DOLPHIN LED LIGHT MUST BE BLINKING
IN ORDER TO PROGRAM. IF AT ANY TIME
DURING PROGRAMMING, THE DOLPHIN LED
STOPS BLINKING, GO BACK TO STEP 1 AND
START AGAIN.
6. On your original remote control, press and hold
the key feature to be learned until the LED on
the Dolphin Remote Control blinks twice. If
the LED does not blink twice, repeat steps 3
through 6.
7. To learn functions onto other learning keys,
repeat steps 3 through 6.
8. To exit learning mode, press and hold SETUP
until the LED blinks twice, then release SETUP
or wait 10 seconds.
9. To test a learned feature, press a device key
(e.g., TV) once where the learning mode was
assigned. Then press the learning key (e.g.,
Guide) where the learned feature is stored.
30