Checking The Codes - Balboa Dolphin II CE User Manual

CHECKING THE CODES

If you have set up the Dolphin using the
"Searching For Your Code" procedure, you may
need to find out which four-digit code is operating
For example, to find out which code is operating
your TV:
1. Turn on your TV.
2. On the Dolphin, press and hold SETUP until the
LED blinks twice, then release SETUP.
3. Enter 9 - 9 - 0. The LED will blink twice.
4. To view the code for the first digit, press 1
once. Wait 3 seconds and count the number of
LED blinks (e.g., 3 blinks = 3) and write down
the number in the leftmost TV Code box below.
NOTE: If a code digit is "0", the LED will
not blink.
5. Repeat step 4 three more times for remaining
digits. Use 2 for the second digit, 3 for the third
digit, and 4 for the fourth digit. Finish writing
down the code in the TV Code boxes below.
6. To check for the codes of your other
components, repeat steps 1 through 5, but
substitute the appropriate key (i.e., VCR, CBL/
SAT, DVD, CD or RCVR) for the component
you are checking. Write down the codes in the
appropriate boxes below.
26
TV Code
■ ■ ■ ■
VCR Code
■ ■ ■ ■
CBL/SAT Code
■ ■ ■ ■
DVD Code
■ ■ ■ ■
CD Code
■ ■ ■ ■
RCVR Code
■ ■ ■ ■