Related Manuals for Balboa Dolphin II
Summary of Contents for Balboa Dolphin II
- Page 1 Balboa Dolphin ® Water Resistant Remote Control Spa Only (CE Version) P/N 40421 Rev. B 12/17/2007...
-
Page 2: Table Of Contents
Troubleshooting ..... . .8 INTRODUCTION ® The Dolphin II Remote is Balboa’s latest generation remote control. It’s packed with easy- to-use features such as: functions. -
Page 3: Installing Batteries
BATTERIES Whenever batteries need to be replaced, the Dolphin will blink twice with every key press. Simply replace the batteries and the remote will be restored to its full functionality, complete with your favorite settings. INSTALLING BATTERIES 1. On the back of the Dolphin, remove the screws that hold the battery cover in place and lift off the battery cover. -
Page 4: Features And Functions
FEATURES AND FUNCTIONS Use the illustration below to locate the Dolphin features and to learn how they function. - Page 5 The LED (red light) blinks to show that the remote control is working and is sending signals. Use these buttons to control available spa functions. Press LT once to turn on the Spa Light. Press P1 once to turn on Pump 1. Press P2 once to turn on Pump 2.
-
Page 6: Spa Addressing
SPA ADDRESSING Your CE-compliant spa does not support addressing. However, in case addressing is ever enabled by accident, follow the steps below to disable. 1. Press the SPA button on the Dolphin once 2. Press and hold SETUP until the LED blinks once. -
Page 7: Specifications
SPECIFICATIONS Remote Control Power 2 AA Batteries Remote Control Dimensions (H x W x D) 9-2⁄16 x 2-10⁄16 x 1-3⁄16 in. 232 x 65 x 31 mm. Remote Control Weight (without Batteries) 8 oz (220 g) NOTE: Specifications are typical. Individual units may vary. -
Page 8: Troubleshooting
TROUBLESHOOTING PROBLEM: LED does not blink when you press a key. SOLUTION: Replace the batteries with two (2) new AA alkaline batteries (see page 3). PROBLEM: Dolphin does not control spa. LED blinks when you press a key, but receiver does not respond.