Programming Cd Control; Setup Codes For Cd Players - Balboa Dolphin II CE User Manual

PROGRAMMING CD CONTROL

Locate the brand name of your CD Player in the
Setup Codes For CD Players section below, and
write it in the following space.
CD Player Brand:
The brands are listed in alphabetical order with
the most popular codes listed first. You will use
one of these codes to program the Dolphin to
operate your CD Player:
1. Turn on the CD Player.
2. On the Dolphin, press CD once. Press and
hold SETUP until the LED blinks twice, then
release SETUP.
3. Enter the first four-digit code for your CD
Player. If you perform this procedure correctly,
the LED will blink twice.
NOTE: If the LED did not blink twice after entering
the code's last digit, repeat steps 2 through
3 and try entering the same code again.
4. Aim the Dolphin at your CD Player and press
POWER once. The CD Player should turn off.
If it does not respond, repeat steps 2-4,
trying each code for your brand until you find
one that works. If it still does not work, try
searching for the code (see Searching For Your
Code on page 25).
5. Write your CD code in the boxes below for
future reference.
NOTE: Remember, to use the Dolphin to operate
your CD Player, press CD first.

Setup Codes for CD Players:

Aiwa
Burmester
California Audio Labs 0029, 0303
Carver
CCE
Classic
Denon
DKK
DMX Electronics
Emerson
Fisher
Garrard
Genexxa
GPX
Harman/Kardon
Hitachi
Integra
JVC
Kenwood
KHL
KLH
20
■ ■ ■ ■
0157
0420
0157, 0179, 0437
0157
1297
0003, 0873
0000
0157
0305
0179, 1325
0420, 0393
0032, 0305
1296
0157, 0173, 1202
0032
0101
0072, 1294
0826, 0626, 0028, 0037, 0190, 0681
1711
1318