Reassigning Device Keys - Balboa Dolphin II CE User Manual

REASSIGNING DEVICE KEYS

The Dolphin can be set up to control a second
TV or VCR, or any combination of four home
entertainment components. For example, to have
the Dolphin control a TV, a Cable Converter, and
two VCRs, you will need to reassign the unused
RCVR key to operate the second VCR as follows:
1. On the Dolphin, press and hold SETUP until the
LED blinks twice, then release SETUP.
2. Enter 9 - 9 - 2. The LED will blink twice.
3. Press VCR once, then press RCVR once.
4. The RCVR key is now ready to be programmed
for your second VCR. (See Programming VCR
Control on page 12.)
To reassign other device keys, repeat steps 1
the following chart for a desired component:
To Reassign
TV as 2nd VCR key:
TV as 2nd RCVR key:
TV as 2nd CBL/SAT key:
TV back to TV
VCR as 2nd TV key:
VCR as 2nd RCVR key:
VCR as 2nd CBL/SAT key:
VCR back to VCR:
RCVR as 2nd TV key:
RCVR as 2nd VCR key:
RCVR as 2nd CBL/SAT key: SETUP - 9 - 9 - 2 - CBL/SAT - RCVR
RCVR back to RCVR:
Upon completion of a reassignment, the LED will
blink twice to confirm your selection. At that time,
you will also need to program the Dolphin to
control the new component (as described earlier
in this document).
Perform Key Sequence
SETUP - 9 - 9 - 2 - VCR - TV
SETUP - 9 - 9 - 2 - RCVR - TV
SETUP - 9 - 9 - 2 - CBL/SAT - TV
SETUP - 9 - 9 - 2 - TV - TV
SETUP - 9 - 9 - 2 - TV - VCR
SETUP - 9 - 9 - 2 - RCVR - VCR
SETUP - 9 - 9 - 2 - CBL/SAT - VCR
SETUP - 9 - 9 - 2 - VCR - VCR
SETUP - 9 - 9 - 2 - TV - RCVR
SETUP - 9 - 9 - 2 - VCR - RCVR
SETUP - 9 - 9 - 2 - RCVR - RCVR
27