Installation Steps; Removal And Installation Of Seats; Removal Of Front Seats - Chery A113 Maintenance Manual

3.7. Use a cross head screwdriver to remove the pre-tension belt
assembly.

4. Installation Steps

The installation steps are reverse to those for removal.
Note:
4.1. Keep the seat belt clean and free of oil, and check it for any
damage.
4.2. The pillar shield should fit securely with the vehicle body
without any looseness, and it should also fit well with the vehicle
ceiling and weather strip s.
4.3. The seat belt adjusting slide baffle of the upper B-pillar shield
should be able to move freely and won't affect the adjustment of the
seat belt, and its fitting clearance with the lower shield should be
consistent and less than 1mm;
4.4. The fitting clearance between the lower B-pillar shield and the
front/rear sill plate should be consistent and less than 1mm;
II. Removal and Installation of Seats
Preparation of Tools: sleeve wrench

1. Removal of Front Seats

1.1. Move the seat by pulling at the movable handle below it, and
when the fixing bolts are shown, use a 13# socket wrench to remove
the bolts in the seat.
Torque: 25±3Nm
1.2. Pull off the seat connector and raise the seat.