Operation; Operating Multiple Cameras; Turning On The Power - Sony BRC-H700 Manual

7.2.2 Operation

The.following.information.enables.easy.camera.
system.operation.with.the.benefit.of.functions.
such.as.pan/tilt/zoom.operation,.preset......
memory,.and.more.
Before.operating,.check.that.the.camera,.the.
Note
RM-BR00.Remote.Control.Unit,.and.peripheral.
devices.are.properly.installed.and.connected.

Turning on the power

1
Connect.the.camera.to.an.AC.outlet.using.the.
supplied.AC.power.adaptor.and.power.cord..
When.the.power.is.turned.on,.the.POWER.lamp.
lights..The.camera.will.automatically.pan.and.tilt,.
and.be.reset.to.the.position.stored.in.POSITION.1.
(Pan/Tilt.Reset.action).
2
Press.the.ON/OFF.switch.on.the.RM-BR00.
Remote.Control.Unit.to.turn.it.on.
3
Turn.on.the.peripheral.devices.
Be.sure.to.turn.on.the.power.of.the.camera.before.
Note
the.power.of.the.RM-BR00.Remote.Control.Unit..
Otherwise,.the.RM-BR00.cannot.recognize.the.
connected.camera.
To turn on/off the camera using the
RM-BR300 Remote Control Unit
While.holding.down.the.POWER.button,.press.the.
CAMERA.button.corresponding.to.the.required.
camera..When.you.turn.the.power.off.using.the.
RM-BR00.Remote.Control.Unit,.the.POWER.lamp.
turns.off.and.the.STANDBY.lamp.lights.on.the.
camera.
To illuminate the panel of the RM-BR300
Remote Control Unit
Press.the.PANEL.LIGHT.button.
6
Remote Operation

Operating multiple cameras

To.assign.camera.addresses.automatically:
1
Make.sure.that.the.camera.address.selector.on.
the.bottom.of.each.camera.is.set.to.0.
2
Turn.on.the.power.of.all.the.connected.cameras.
and.the.RM-BR00.Remote.Control.Unit.
3
Hold.down.the.RESET.button.and.press.the.
POWER.button.on.the.RM-BR00..The.RM-BR00.
recognizes.the.connected.cameras.and.assigns.
them.camera.addresses,.1.to.7,.automatically.in.
the.connected.order.
4
To.confirm,.press.the.POWER.button.on.the......
RM-BR00.and.check.that.the.CAMERA.buttons.
light.
To assign camera addresses manually
Set.one.of.the.camera.addresses,.1.to.7,.using.the.
camera.address.selectors.on.the.bottom.of.each.
camera.
Camera address selectors
Set.the.address.of.the.camera..This.is.normally.set.
to.0..With.this.setting,.addresses.are.assigned.to.
the.cameras.automatically.in.the.connected.order.
by.pressing.the.POWER.button.while.holding.down.
the.RESET.button.on.the.RM-BR00.Remote.Control.
Unit..You.can.assign.the.camera.address,.1.to.7,.
manually.by.setting.these.selectors.as.follows:
Camera
0 1 2 3
address
Switch 1 OFF ON OFF ON
Switch 2 OFF OFF ON ON
Switch 3 OFF
OFF OFF OFF
4 5 6 7
OFF ON OFF ON
OFF OFF ON ON
ON ON ON ON
Switch 4 is not used.