Sony BRC-H700 Manual page 17

5.1.3 BRC-300/300P
Rear
1 2 3
OFF ON
75 IR SELECT
EXT SYNC IN VIDEO S VIDEO
75 Ω termination switch
This.switch.is.used.when.an.external.sync.signal.
is.utilized..Set.it.to.OFF.when.this.camera.is.in.
the.middle.of.a.daisy-chain.connection.of.
multiple.cameras..Set.it.to.ON.when.the......
camera.is.at.the.end.of.a.daisy-chain..........
connection.
IR SELECT switch
Selects.the.camera.number.when.you.operate.
multiple.cameras.with.the.same.IR.Remote.
Commander.Unit.
Remote sensor
This.is.the.sensor.for.the.supplied.IR.Remote.
Commander.Unit.
VISCA RS-422 connector
EXT SYNC IN connector
VIDEO connector
(Composite out)
S-VIDEO connector
VISCA RS-232C IN connector
Connects.to.the.RM-BR00.Remote.Control.Unit..
When.you.join.multiple.cameras,.connect.it.to.
the.VISCA.RS-C.OUT.connector.of.the.
previous.camera.in.the.daisy.chain.
VISCA RS-232C OUT connector
When.you.join.multiple.cameras,.connect.it.to.
the.VISCA.RS-C.IN.connector.of.the.next.
camera.in.the.daisy.chain.
DC IN 12V connector
Card slot
18
Location and Function of Parts
1 2 3 4 5 6 7 8 9
VISCA RS-422 !
DC IN
IN VISCA RS-232C OUT
12V
Bottom
Ceiling bracket mounting screw holes
Tripod screw holes
BOTTOM switches
Setting of the BOTTOM switches
Switch 1
(No connection)
Always.keep.it.OFF.
Switch 2
(RS-232C/RS-422 selector)
Set.to.ON.for.RS-4,.or.OFF.for.RS-C..
Switch 3
(Communication baud rate selector)
Set.to.ON.for.8400.bps,.or.OFF.for.9600.bps.
Switch 4
(Infrared signal output switch)
Set.to.ON.to.enable.an.infrared.signal.output,.
or.OFF.to.disable.the.output.
Camera address selectors
Set.the.address.of.the.camera..Normally.set.to.
0..With.this.setting,.addresses.are.assigned.to.
the.cameras.automatically.in.the.connected.
order.by.pressing.the.POWER.button.while.
holding.down.the.RESET.button.on.the.
RM-BR00.Remote.Control.Unit..You.can.assign.
the.camera.address,.1.to.7,.manually.by.setting.
these.selectors.as.follows:..
Camera
0 1 2
address
Switch 1 OFF ON OFF
Switch 2 OFF
OFF ON
Switch 3 OFF OFF OFF
Please.note.that.the.same.camera.address.
Note
cannot.be.assigned.to.two.or.more.different.
cameras..Furthermore,.you.must.set.the.switches.
before.you.turn.on.camera.power.
(1/4-20UNC)
3 4 5 6 7
ON OFF ON OFF ON
ON OFF OFF ON ON
OFF ON ON ON ON
Switch 4 is not used.