Texas Instruments TI-89 Titanium Short User Manual page 125

Common Error and Notification Messages
Shown on:
Sending unit
Sending unit
Connectivity
Message and Description:
This is displayed after several seconds if:
• A cable is not attached to the sending unit's
link port.
– or –
• A receiving unit is not attached to the other
end of the cable.
– or –
• The receiving unit is not set up to receive.
Press N or ¸ to cancel the transmission.
Note: The sending unit may not always display this
message. Instead, it may remain BUSY until you
cancel the transmission.
The receiving unit does not have the correct
certification for the operating system (OS) or Flash
application being sent.
119