Table of Contents
Advertisement
Samsung iDCS100
• PROGRAM SYSTEM SPEED DIAL NAMES
[MMC 706]
This procedure allows a name to be assigned for each system speed dial location, up
to 11 characters. This name enables you to locate the speed dial number when you are
using the directory dial feature.
Open customer programming and follow these instructions.
ACTION
1. Press Transfer (or TRSF) 706
Display shows
2. Dial the system speed number (e.g., 505)
OR press the VOLUME keys to select the entry
number and press the right soft key to move the
cursor
3. Enter the name using the procedure described in
Program Station Names
4. Press the right soft key to return to step 2 OR
press the F key to return to
Speed Dial Numbers [MMC 705, step 4, above]
5. Press Transfer (or TRSF) to store and
exit programming OR press SPEAKER to store
and advance to the next program
• PROGRAM PERSONAL SPEED DIAL
NUMBERS FOR STATIONS
[MMC 105]
Individual station users can program their own numbers, but in cases where this is not
practical or not straightforward (e.g. for single line telephones), this program allows a
system administrator to view or change a station's speed dial numbers. The station
speed dial codes are 00–49. Each station can have up to 10 numbers (00–09) by de-
fault, though more can be assigned (in blocks of 10) up to a maximum of 50 numbers.
Each speed dial number consists of a line access code and the telephone number to
be dialled. The access code can be any line group, individual line, station group or in-
dividual extension. The speed dial number can be up to 24 characters long including ,
#, FLASH and PAUSE.
Note: If Least Cost Routing (LCR) is being used, the LCR access code must be entered.
Refer to the section
Program System Speed Dial Numbers
special keys B–F you can use during this programming procedure.
20
Program System
System Administration Guide
DISPLAY
SYS SPEED NAME
500:
SYS SPEED NAME
505:
SYS SPEED NAME
505: SAMSUNG
(above) for full details of the
Advertisement
Table of Contents
