Security Menu; Power Menu; Boot Menu - BenQ Joybook R46 Series User Manual

Security menu

The Security menu contains the security settings, which
safeguard your system against unauthorized use.
Do NOT set the BIOS security password without having
memorized it or written it down and stored it with your Joybook
warranty documentation. Should you happen to forget or mislay
the password once set, you will be greatly inconvenienced in
gaining subsequent access to your Joybook.
• Change Supervisor Password: This set of password controls the
system supervisor's access to the whole BIOS setup utility. It
must be set before User Password can be set. When typing the
password, first make sure Num Lock is off, and then type your
password in the entry field and press <Enter>. Confirm your
password by typing it again and pressing <Enter>.
• Change User Password: This set of password controls the user's
access to the BIOS setup utility. When typing the password,
first make sure Num Lock is off, and then type your password
in the entry field and press <Enter>. Confirm your password
by typing it again and pressing <Enter>.
If Supervisor Password and User Password are both set, you
can enter either one of them during the password prompt. To
have full privileges in BIOS setup, enter Supervisor Password.
• Hard Disk Security Setting: allows you to configure the
security of your hard disk.
• I/O Interface Security: allows you to disable input/output
interfaces to prevent system data from being stolen.

Power menu

The Power menu allows you to configure power management of
your system.
• LCD Power Saving: When this option is enabled, LCD
brightness becomes dimmer when the system is on battery.

Boot menu

The Boot menu contains the boot configuration settings of the
system. A list of devices will be displayed under Boot priority
order.
• Boot Settings Configuration: allows to configure boot settings
that are applied during system startup.
• Quiet Boot: This item controls the display of BenQ
logo during system startup.
• When enabled, BenQ logo will be displayed during
system startup.
• When disabled, diagnostic texts (POST messages)
will be displayed during system startup.
• Boot Device Priority: sets the sequence of boot devices. The
system will try to boot from the first device. If it is not
available, the system will try the next boot device.
a. Use <#> or <$> to select a device.
b. Press <Enter>, and then press <#> or <$> to select a
device from the list.
c. Press <Enter> to confirm your selection.
• Hard Disk Drives: specifies the Boot Device Priority sequence
from hard disks that are available.
• CD/DVD Drives: specifies the Boot Device Priority sequence
from CD/DVD drives that are available.
• Onboard LAN Boot ROM: decides whether to invoke the boot
ROM of the onboard LAN chip.
Using BIOS setup 43