Auto Color Balance (Automatically Calibrate Chip Adc Parameter By Using Chip Internal Dac.) - Dell 2208WFP Service Manual

Auto Color Balance (Automatically calibrate chip ADC parameter by using chip internal
DAC.)
5.1 If it is a new-built set, press "Auto/Plus" button to execute "Auto Color" at standard video pattern
pattern
5-MOSAIC
5.2 Please confirm the following steps to perform "Auto Color Balance":
- Connect the VGA cable with the standard video pattern generator and display
monitor.
- Press "Power" button to power off the monitor.
- Press "Menu" and "Auto/Plus" buttons simultaneously; then press "Power" button to power on the
monitor.
-
Press "Plus Key", select"Other Settings Menu" ,then Press "Plus Key"and choose factory at bottom
- Set BurnIn Mode item to ON, then execute Auto Color item.
- After the "Auto Color Balance" process finished, go back to "Other Settings Menu", and press "Factory Reset" to exit Factory
mode
Upgrade Firmware to Serial via Flash Cable by ISP_Tool V4.100.exe
7.1 Connect the monitor and PC follow Fig 11
32
Service Manual
pattern on the
5-MOSAIC