Upgrade Firmware To Serial Via Flash Cable; Auto Color Balance (Automatically Calibrate Chip Adc Parameter By Using Chip Internal Dac.) - Dell 2209WA Service Manual

Lcd monitor
Hide thumbs Also See for 2209WA:
Table of Contents

Advertisement

Service Manual
plugging in the VGA /DVIcable. Exit Burn-in mode method as followe: plugging in the
VGA/DVI cable, press "Menu" button to call out OSD Main Menu, Press "Plus Key"to
select"Other Settings submenu"then choose Factory reset.
Auto Color Balance (Automatically calibrate chip ADC parameter by
using chip internal DAC.)
5.1 If it is a new-built set, press "Auto/Plus" button to execute "Auto Color" at
standard video pattern
5.2 Please confirm the following steps to perform "Auto Color Balance":
- Connect the VGA cable with the standard video pattern generator and display
pattern on the monitor.
5-MOSAIC
- press "Power" button
- Press "Menu" and "
to turn on the monitor. After power on, the device is enter factory
modode ,press "
- choose Auto Color item, then execute Auto Color item.
- After the "Auto Color Balance" process finished, go back to "Other Settings Menu", and press
"Factory Reset" to exit Factory mode
Upgrade Firmware to Serial via Flash Cable by ISP_Tool V4.100.exe
7.1 Connect the monitor and PC follow Fig 11
pattern
5-MOSAIC
on right corner of front bezel
Ù"(
Plus )buttons together, and then press "Power" button
Ù"(
Plus )buttons to call out factory menu
40
to turn off the monitor.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents