Burn-In Pattern; Auto Color Balance (Automatically Calibrate Chip Adc Parameter By Using Chip Internal Dac.) - Dell E2209Wf Service Manual

Burn In: Enable or disable the Burn-in mode by choosing ON or OFF.
Reset Timer: Reset the "Turn-on time" of the panel to 0H0M.
Color Temp: The R, G, B of Blue Preset (9300K), Red Preset (5700K) and Normal Preset (6500K) are generated
from scaling chip's back-end white-balance program.
Time: Turn-on time of the panel.
DEBUG: Debug tool of scale IC U104.
Dell panel P/N
LCD supplier
Samsung
INL
CMO

Burn-in pattern

Burn-in pattern will self-generate automatically without VGA and DVI cable plugged in when the monitor set at
Burn-in on mode and burn-in pattern will not be stopped until plugging in the VGA cable. Exit Burn-in mode
method as followe: plugging in the VGA/DVI cable, press "Menu" button to call out OSD Main Menu, Press "Plus
Key"to select"Other Settings Menu"then pop submenu and choose Factory reset.
Auto Color Balance (Automatically calibrate chip ADC parameter by using chip internal
DAC.)
5.1 If it is a new-built set, press "Auto/Plus" button to execute "Auto Color" at standard video pattern
pattern
5-MOSAIC
5.2 Please confirm the following steps to perform "Auto Color Balance":
- Connect the VGA cable with the standard video pattern generator and display
monitor.
- Press "Power" button to power off the monitor.
- Press "Menu" and "Auto/Plus" buttons simultaneously; then press "Power" button to power on the
monitor.
-
Press "Plus Key", select"Other Settings Menu" ,then Press "Plus Key"and choose factory at bottom
- Set BurnIn Mode item to ON, then execute Auto Color item.
- After the "Auto Color Balance" process finished, go back to "Other Settings Menu", and press "Factory Reset" to exit Factory
mode
Upgrade Firmware to Serial via Flash Cable by ISP_Tool V4.100.exe
7.1 Connect the monitor and PC follow Fig 11
Panel
22"W
22"W
22"W
26
Supplier P/N
LTM220M1-L01
MT220WW01-V0
M220Z1-L03
Service Manual
Dell P/N
MY228
D569C
P546G
pattern on the
5-MOSAIC