Dell panel P/N
LCD supplier
AUO
LPL
Burn-in pattern
Burn-in pattern will self-generate automatically without VGA cable plugged in when the monitor set at
Burn-in on mode and burn-in pattern will not be stopped until plugging in the VGA cable. Exit Burn-in
mode method as followe: plugging in the VGA cable, press "Menu" button to call out OSD Main Menu,
Press "Plus Key"to enter Factory reset.
Auto Color Balance (Automatically calibrate chip ADC parameter by using chip
internal DAC.)
5.1 If it is a new-built set, press "Auto Color" button on Factory menu to execute "Auto Color" at
standard video pattern
5.2 Please confirm the following steps to perform "Auto Color Balance":
- Connect the VGA cable with the standard video pattern generator and display
pattern on the monitor.
- Press "Power" button to power off the monitor.
- Press "Menu" and " " buttons simultaneously; then press "Power" button to power on the
monitor.
-
Press " " to call out factory menu
- Execute Auto Color item.
- After the "Auto Color Balance" process finished, go back to "Other Settings Menu", and press "Factory Reset" to
exit Factory mode
Upgrade Firmware to Serial via Flash Cable by ISP_Tool V4.100.exe
7.1 Connect the monitor and PC follow Fig 11
Panel
18.5"W
18.5"W
pattern
5-MOSAIC
Supplier P/N
M185XW01
LM190WH1
26
Service Manual
Dell P/N
T022G
W368G
5-MOSAIC