Problem Solution; Maintenance - Worx WX372 Safety And Operating Manual

battery pack connections with heavy-duty
adhesive tape to prevent short circuit and
energy discharge. Do not attempt to open or
remove any of the components.

PrOblem sOlutiOn

1. WHy DoeS tHe DRIll Not tURN oN
WHeN yoU PReSS tHe SWItcH?
The forward and reverse switch, which is on
top of the trigger, is positioned in the lock
function. Unlock the forward and reverse
switch putting it into the required rotation
position. Push the trigger and the drill will
start to rotate (See Fig. B).
2. tHe DRIll StoPS BefoRe tHe
ScReW IS coMPletely tIGHteNeD.
WHy?
Verify the torque position of the torque
adjustment ring, you can find the torque
adjustment ring between the chuck and the
drill body. Position 1 is the lowest torque
(screw driving force) and position 22 is the
highest torque (screw driving force). Position
is for drill operation. Regulate the torque
adjustment ring to a higher position to reach
the best result (See Fig.E).
3. I cAN Not fIt tHe BAtteRy INto
tHe BAtteRy cHARGeR. WHy?
The battery can be inserted into the charger
only in one direction. Turn the battery around
until it can be inserted into the slot, the red
LED light should turn on when the battery is
charging.
4. ReASoNS foR DIffeReNt BAtteRy
PAck WoRkING tIMeS
Charging time problems, as above, and
having not used a battery pack for a prolonged
time will reduce the battery pack working time.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions such
as large screws into hard wood will use up the
battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack
below 0 C and above 30
o
performance.
Lithium-Ion cordless
hammer drill
C as this will affect
o

maintenance

Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
WX372 WX372.1
WX372.9
11