Because our products are subject to continuous improvement SVC reserves the right to modify product designs and specifications without notice and without incurring any obligations. E & O.E
REMEDY
• If you are using a TV as a slave monitor, you may need
to set the channel as AUX (or sometimes referred to as
"TV / Video").
• Please check if the wiring between the monitor and the
Quad Processor is correct.
• Make sure that the camera is receiving power
• Check the power source cord connections
• Check that there is power at the outlet
• Set the Alarm Polarity according to whether your PIR
motion sensor is Normally Open or Normally Closed.
• If no motion sensors are connected, set that channel's
Alarm Polarity to OFF.
• Connect the video cable on Channel 1 before Power
ON. The system will automatically detect electrical