Slideouts; Termination Valve; Tv Antenna - Damon Astoria Pacific Edition Owner's Manual

Table of Contents

Advertisement

Poor Reception.
Have you entered your correct current location zip code?
Do you have the TV tuned to channel 3 or 4? (Same channel as the output of the
receiver)
Be sure there are no trees, buildings, mountains, etc. in the line of sight to the
satellite.
Check connections at the receiver, TV and antenna.
Fine tune reception by slowly moving the antenna left, then right until you find
the position that gives the highest signal strength. It is important that you turn the
antenna slowly. The signal is digital and it takes a few seconds to lock on.
Room moves in and out very slowly, binds or squeaks.
Grease the slide-out tubes and rollers.
Grease marks appear on the carpet where the rollers are located.
The rollers are not a true sealed roller, so this may happen over time. Take precautions
when lubricating.
Water is getting in at the bottom corners of the room.
Verify the exterior seals are against the room at the top corners and not turned in
when room is out. Also, check for voids in the seal on the roof.
Room will not move in or out.
Ensure ignition switch is in the OFF position.
Check the auto-resetting fuse located by the slide out motor. (See the manufacturers
manual)
Check battery condition and state of charge. Recharge if necessary.
Rollers leave tracks in the carpet as the room extends.
This is normal. There are many pounds of weight pressing these rollers down on
the carpet and rollers will compress the nap of the carpet down. Raking the nap or
vacuuming will solve the problem.
Termination valve leaks.
Debris keeps valve from seating. Clear debris from and around valve O-ring
set.
Bad gasket. Have a Damon dealer or a qualified RV technician replace gasket with
new.
Poor TV reception.
Power jack is not turned on. Turn power jack switch to ON.
Bad connections at TV or wall plate. Make sure the connections are good
at both TV and wall plate.
Antenna not pointed in direction of sending station. Point antenna in proper
direction.
Troubleshooting
SLIDEOUT

TERMINATION VALVE

TV ANTENNA

9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents