Propane System; Abs Plastic Parts; Alignment; Awning - Damon Astoria Pacific Edition Owner's Manual

The propane system should be checked regularly for leaks and road damage. Follow
the lines, looking for kinks or flattened spots that may have occurred during travel or
maintenance on the recreational vehicle. A qualified propane service technician using
proper equipment should check the entire system annually or whenever you suspect a
problem.
The line pressure for propane appliances should be checked at least every six months.
Most propane suppliers have this equipment to do the test for you.
All service procedures should be performed only by a certified propane
service technician.
Insects can build nests in the burners of the various appliances and equipment. The
burner and burner orifice of the propane appliances should be cleaned out by an
authorized dealer or repair facility anytime circumstances or conditions warrant, but no
less frequently than on an annual basis.
Some components of the recreational vehicle are constructed of strong, lightweight ABS
plastic. Sometimes, it may be necessary to remove stains, or generally clean. A mild
solution of soap and water will clean many stains, and should be used initially. Tougher
stains may require stronger cleaners, but be sure to read the label to determine if the
product is recommended for use on plastics. Avoid abrasive cleansers (even the liquid
and cream types), alcohol based products, and solvents such as acetone and MEK.
Gasoline and kerosene should not be used because of the damaging effect they have
on the plastic surface, as well as the fire hazard they present. Often the damage caused
by solvents, alcohol, and oil based products may not be immediately noticeable, but the
plastic is made weaker, and thus more prone to stress cracking.
The front suspension and steering system of this vehicle was factory aligned using
highly accurate equipment prior to delivery to the dealership. However, we recommend
that alignment be checked and if necessary, adjusted after you have fully loaded the
motorhome according to your personal needs. Thereafter, the alignment should be
inspected annually to help prevent uneven tire wear. All alignments and incurred costs
are the responsibility of the retail owner.
Check that the top and bottom bracket screws are tight at the start of each camping
season.
1. Lubricate the rafter arms and support arms using paraffin wax or silicone spray.
Also lubricate the threads on the knobs.
2. Periodically clean the awning fabric as follows: For a vinyl material use a mixture
of 1/4 cup of dish soap and 1/4 cup of bleach mixed with 5 gallons of warm water.
Liberally apply this mixture on the top of the fabric, then roll the awning up for 5
minutes. This will apply the mixture to the bottom as well. Roll the awning back out
and hose off with fresh water. Repeat if necessary. Allow to dry before rolling back
up. Avoid the use of caustic household cleaners, mildew removers or hard bristle
brushes. Do not scrub!
Chapter 10 - Care and Maintenance

PROPANE SYSTEM

ABS PLASTIC PARTS

ALIGNMENT

AWNING