Mercury 200 User Manual page 59

b. Turn the ignition key switch to the "ON" position for three
seconds. This operates the electric fuel pump.
c. Turn the ignition key switch back to the "OFF" position, and
squeeze the primer bulb again until it feels firm. Turn the
ignition key switch to the "ON" position again for three
seconds. Continue this procedure until the fuel line primer
bulb stays firm.
7. Do not advance the throttle‑only feature on the remote control
for starting.
8. Turn the ignition key to "START" position. Release the key
when engine starts. If engine fails to start in 10 seconds, return
the key to "OFF" position, wait one second and try again.
NOTE: The electronic starting system will automatically prime
(choke) the engine and increase idle speed for starting.
9. Check for a steady stream of water flowing out of the water
pump indicator hole.
OPERATION
53
27242
19804