Mercury 200 User Manual page 109

OUTBOARD INSTALLATION
3. Mark the center on the shift cable midway between the forward
and reverse marks.
a - Center mark
4. Align the cable end guide against this center mark when
installing the cable to the engine.
5. Position the remote control and outboard into neutral position.
6. Slide the anchor pin forward until resistance is felt, then slide
the anchor pin toward the rear until resistance is felt.
7. Center the anchor pin between these resistance points.
a - Anchor pin
Adjusting the Shift Cable
1. Align the shift cable end guide with the center mark as
instructed in Locating the Center Point of the Shift Cable.
a - Center mark
a
a
103
4361
a
28746
4362