Component Replacement; Replacement Of The Door Seal; Regular Service - Baxi FURNESS Operating & Installation Manual

COMPONENT REPLACEMENT

Step 1 Ensure the fire is cold. Turn off the gas
supply at the gas service cock.
Step 2 Remove the coals.
Step 3 Remove the rear matrix plate, undo the
three retaining nuts.
Step 4 Remove the control valve heat shield.
Undo the two retaining screws located
on the left-hand side of the shield.
Slide the heat shield backwards and lift
out carefully. Do not damage the
covering.
Step 5 Disconnect the gas supply pipe at inlet
to fire.
Step 6 Remove the gas control knob (pull off)
and remove the M15 control valve
retaining nut (17mm spanner).
Step 7 To remove the burner bracket, burner and
control valve assembly, undo the two
retaining screws located on the front ledge
of the appliance.
After component replacement, ensure that a
check on the gas tightness of any new joint is
made by using a soap/water solution.
REPLACEMENT OF THE DOOR
SEAL
Step 1 Remove the door, by opening the door and
gently tapping the door upwards, this will
lift the door off of its hinges.
Step 2 Remove the old door seal and old
adhesive, using a wire brush ensuring that
the surface is clean and dust free.
Step 3 Apply the new adhesive to the door
casting.
Baxi Gas Stoves
Step 4 Starting at one end press the new door seal
into the adhesive, continue around the
door, making sure that the two ends of the
seal are touching. Cut off any excess seal.
Step 5 Allow the adhesive time to cure
(approximately 2 hours depending on the
adhesive).
Step 6 Carefully refit the door and close.

REGULAR SERVICE

See "SAFTEY NOTICES" ref coal set
Any soot or debris should be removed from the
fuel bed regularly.
Step 1 Isolate the gas supply to the fire using
the gas cock supplied at installation.
Step 2 With the appliance cold, open the main
door by turning the handle through 180°
degrees.
Step 3 Carefully remove and clean the fuel effect
coals of any soot deposits with a soft
brush.
Step 4 Remove any soot deposits from inside
the fire using a vacuum cleaner.
(See note under 'Coal set' on page 4)
Step 5 Replace the coal set as described in
"Arranging The Coals" on page 7.
SERVICING
19