Table of Contents
Advertisement
OPERATION AND INSTRUCTIONS
" WARNING
THIS MANUAL MUST BE READ
CAREFULLY BY ALL INDIVIDUALS
WHO HAVE OR WILL HAVE THE
RESPONSIBILITY FOR USING OR
SERVICING THE PRODUCT. Like
any piece of complex equipment,
the unit will perform as designed
only if it is used and maintained in
accordance with the manufactur-
er's instructions. OTHERWISE IT
COULD FAIL TO PERFORM AS
DESIGNED
AND
RESULT
SEVERE PERSONAL INJURY OR
DEATH.
The warranties made by Mine Safety
Appliances Company with respect to
the product are voided if the product is
not used and serviced in accordance
with the instructions in this manual.
Please protect yourself and others by
following them. We encourage our cus-
tomers to write or call regarding this
equipment prior to use or for any addi-
tional information relative to use or
repairs. During regular working hours,
cal l 1-877-MSA-FIRE.
By order of the US Department of
Commerce, in conjunction with the US
Department of State and DOD, this
Thermal Imaging Camera may not be
resold, re-exported, transferred, or oth-
erwise disposed of outside of the coun-
try named as the location of foreign end
use, either in its original form or after
being incorporated into other end
items,
without
the
approval of the US Department of
Commerce. Violation of this regulation
may result in fine and/or imprisonment.
© MINE SAFETY APPLIANCES COMPANY 2009 -
All Rights Reserved
This manual is available on the internet at
www.msanet.com
Manufactured by
MSA NORTH AMERICA
P.O. Box 427, Pittsburgh, Pennsylvania 15230
(L) Rev 1
EVOLUTION
EVOLUTION
Thermal Imaging System
IN
prior
written
5200 and
®
5200HD
®
2
10075165
Advertisement
Table of Contents
Related Manuals for MSA EVOLUTION 5200
Summary of Contents for MSA EVOLUTION 5200
- Page 1 During regular working hours, cal l 1-877-MSA-FIRE. By order of the US Department of Commerce, in conjunction with the US Department of State and DOD, this...
-
Page 2: Table Of Contents
BEFORE USE/DESCRIPTION ....... . .1 Figure 1. The Evolution 5200 TICand Evolution 5200HD2 TIC ....1 INTRODUCTION . - Page 3 TIC Configurations and Accessories ........9 Evolution 5200 and Evolution 5200HD TIC Standard Components .
- Page 4 Figure 12. Location of Power Cable, Phoenix Connector, and Internal Fuse ..17 MSA FACTORY REPAIR & SERVICE POLICY CARD ......18...
-
Page 5: Before Use/Description
It is not recommended that the camera run for extended periods in high-heat conditions. The Evolution 5200 Series TICs are intended as an aid to fire and rescue operations in conditions Figure 1. The Evolution 5200 TIC... -
Page 6: Specifications
Specifications • the Evolution 5200 TIC detects thermal energy radiated/generated from surrounding CONSTRUCTION Flame retardant objects and converts this energy into a visual (material passes simulated NFPA image. direct flame exposure • Hot objects appear white. test). IP67 [withstands immersion to 3 feet •... -
Page 7: Warnings And Cautions
2. Electromagnetic radiation (radio transmissions) at certain high temperature extremes. Tests may cause interference. Minimize nearby radio on the Evolution 5200 and Evolution 5200HD transmissions if excessive interference occurs. TIC indicate that they will provide an acceptable image when subjected to an 3. -
Page 8: Operation
To activate, press the POWER button until: ready for use. • The 2X indicator appears on the camera's display (above the green system status LED). NOTE: The Evolution 5200 or Evolution 5200HD POWER button has a To return to Normal Mode from 2X Digital Zoom... -
Page 9: On-Screen Indicators
Status, Battery Life and Overtemp status. When temperature range. When the Evolution 5200 TIC the TIC is turned ON, all LEDs "flash" for two to is in Low Sensitivity mode, the letter "L" appears in three seconds;... -
Page 10: Warning
Flashing Green indicates the TIC is ON and in power-saving Standby mode. If you plan to use the TIC for viewing or recording direct video, the Evolution 5200 and Evolution F - Battery Status Indicator - 5200HD TICs are equipped with an SMA-type... -
Page 11: Battery Care And Installation
RECHARGEABLE BATTERIES Do not use the charger outdoors. FAILURE TO FOLLOW THE ABOVE WARNING CAN RESULT IN SERIOUS The Evolution 5200 and Evolution 5200HD TICs PERSONAL INJURY OR DEATH. run on one Lithium Ion battery; one battery is required for TIC operation. - Page 12 • With high capacity batteries, this • Phase 4 - MAX Charge: phase can sometimes be the longest • All three LEDs are ON at the of the three phases same time • With some low capacity batteries and • Charging is complete and the battery batteries reaching the end of their life, is fully charged...
-
Page 13: Tic Accessories
System. There are several part numbered kits to housing if the TIC is used with a truck- choose from. Please see the Evolution 5200 or mounted charger, as it may interfere with Evolution 5200HD Brochure for complete making adequate contact. -
Page 14: Evolution 5000 Series Universal Truck-Mounted Charging System Operation
Power Status LED Indicators System Fault GREEN Power On/ System Operational Any LED indication other than those listed indicates faulty operation and the unit must be returned to MSA for service. Battery LED Indicators No Battery Installed GREEN Charge Completed... -
Page 15: Figure 9
NOTE: For optimal performance, the battery charger should be operated at tempera- tures between 50 to 85° F (10 to 29° C). Charging batteries outside this tempera- ture range may result in a charging error and/or premature battery degradation. Charging batteries in environments greater than 100°... -
Page 16: Evolution 5000 Series Universal Truck-Mounted Charging System Installation
Select a large flat surface area for mounting that the bottom and add a second allows easy access for Evolution 5200 TIC storage neoprene washer to each of the and adequate cable length for electrical bottom two bolts. -
Page 17: Electrical Connections
Electrical Connections Installation Power Requirements 1. Connect the positive lead (red) on the prepared wire end of the power supply line to The Truck-Mounted Charging System can a fused, in-line connection with a master consume enough current to eventually fully drain switch. -
Page 18: Thermal Imaging Camera Warranty
4. Exclusive Remedy—It is expressly agreed that the Original end-user’s sole and exclusive remedy for breach of the above warranty, for any tortious conduct of MSA, or for any other cause of action, shall be the repair and/or replacement, at MSA’s option, of any equipment or parts thereof, that after examination by MSA are proven to be defective. -
Page 19: Evolution Thermal Imaging Camera Extended Service Application
(or Fax 1-412-967-3053) One application must be submitted for EACH Evolution TIC. Phone 1-800-MSA-2222 for assistance in completing this form. 1. Extended warranty requests MUST be exercised within the first 6 months from the date of manufacture. The last three characters (MYY, or “month-year-year”) of the TIC’s serial number (located in the battery compartment of the TIC) will dictate this time-frame... -
Page 20: Maintenance And Adjustments
MAINTENANCE AND ADJUSTMENTS GENERAL MAINTENANCE TROUBLESHOOTING THE TRUCK- MOUNTED CHARGING SYSTEM After each use, inspect: • the Evolution 5200 TIC for structural, heat Troubleshooting Guidelines and/or chemical damage SYMPTOM PROBLEM/SOLUTION • the mechanical hardware to ensure no Check power connections. -
Page 21: Service
SERVICE Field Repairs and Maintenance NOTE: Only remove the Truck-Mounted Charging If your Evolution 5200 Thermal Imaging Camera System's back cover in an ESD-protected (TIC) is in need of service or repair, please contact area with personal grounding system the MSA Service Center at 1-877-MSA-FIRE. -
Page 23: Evolution 5000 Series Tic Spare Parts List
EVOLUTION 5000 SERIES TIC SPARE PARTS LIST PART SPARE PART NUMBER 10041100 Charger 110 VAC with Cigarette Lighter Adapter 10038412 Lithium Ion Battery 10067565 Evolution 5000 Series Universal Truck-Mounted Charging System 10039516 Wrist Strap 10039515 Shoulder Strap 10040226 Retractable Lanyard 10040005 Caribiner 10039603...