Motorola DS6878 Product Reference Manual page 171

Attach the modular connector of the USB interface cable to the host port on the bottom of the digital scanner
1.
cradle (see Connecting the CR0078-S/CR0008-S Series Cradle on page 1-8
Series Cradle on page
Plug the series A connector in the USB host or hub, or plug the Plus Power connector in an available port of
2.
the IBM SurePOS terminal.
Select the USB device type by scanning the appropriate bar code from
3.
On first installation when using Windows, the software prompts to select or install the Human Interface Device
4.
driver. To install this driver, provided by Windows, click Next through all the choices and click Finished on the
last choice. The cradle powers up during this installation.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
5.
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different than those illustrated, but the steps to connect the digital scanner
cradle remain the same.
If problems occur with the system, see
1-10).
Troubleshooting on page
USB Interface
or Connecting the CR0078-P
USB Device Type on page
Figure 7-1
3-4.
7 - 3
7-5.
are examples