Table of Contents
Advertisement
ROMA 55 FF
14.3 Prepare the wall
1. Using the template provided decide upon the position of the boiler.
2. Mark and drill four holes 10 mm diameter 60 mm deep.
3. Insert wall plugs provided and screw in the hexagon headed screws provided into the upper holes to within about
5 mm of the wall face.
4. For rear exit flues, mark the centre of the flue hole on the rear flue. Go to step 6.
5. For side exit flues, extend the centre of the flue hole marked on the rear wall, horizontally to the side wall, and mark,
as shown.
6. Drill a 115 mm diameter hole, horizontally through the exit wall. A slight decline away from the boiler is acceptable.
An incline is not.
Diameter min. 115 mm
Diameter min. 115 mm
Boiler = 370 mm
22
Advertisement
Table of Contents
