Installation; Process Overview - Bontrager NODE 1.1 Instructions For Use Manual

INSTALLATION

Getting your Node up and running is easy and takes only about 10 minutes.

Process Overview

It will help you through the process if you take the time to completely read the
installation section before you start. For example, you cannot complete the setup
process (#3 below) if the sensor cannot read the magnet in the wheel (#1).
Here are the steps in the process (explained more fully in the following pages):
1. Install the speed sensor and wheel magnet (see the instructions packaged
with the sensor). Install optional accessory sensors.
2. Attach the computer to the handlebar or stem.
3. Setup your preferences for time, miles, etc.
4. "Pair" the computer (make the computer recognize and remember the radio
signal from the sensor).
Sensors
Your NODE is not packaged with sensors. You can purchase sensors for the
NODE from your Bontrager dealer. For installation instructions for a sensor, see
those packaged with the sensor.
The NODE can read up to four signals or sensors:
• Speed
• Cadence
• Heart rate
• Power
• Combo (speed and cadence)
You can add sensors at any time. However, additional setup work is required
each time you add a sensor.
Tools Required
• Screwdriver, small phillips type
• Coin
Parts List
A
E
D
Figure 11. Parts Included with Your Node Computer.
A. Handlebar clamp
B. Rubber pad
C. Brackets
D. Battery
E. Rubber shim
F. Zip ties
G. Screw & washer
H. Battery cover
I. Rubber o-ring
J. Heart rate strap ( )
NODE 2.1 only
C
F
I
J
H
G
B
6
6