Bontrager NODE 1.1 Instructions For Use Manual page 13

8. The odometer shows your accumulated distance.
You can skip this step and leave the value at 00000 by pressing
and then go to step 10.
To change the highlighted number, press
To select a value and proceed to the next digit, press
9. Repeat for each of the other four digits:
To change the highlighted number, press
To select a value and proceed to the next digit, press
If desired, you can go back to the first digit (and then the other digits) by pressing
To save the Odometer and proceed to the Pairing Process, press
10. After saving the odometer settings, the Node goes into the Pairing Process.
For the Node to Pair to a sensor signal, you must activate the sensor so that
it sends a signal:
• Speed: spin the wheel
• Cadence: rotate the crankarm
• Heart rate: wear the chest strap
• Power: rotate the crankarm (or, for a hub sensor, turn the wheel)
The next page explains the display during pairing.
11. When the screen shows "Setup Complete," press
and switch to the Ride mode.
s 1
,
T B
or .
s 2
.
T B
or .
s 2
.
s 2
.
s 1
.
s 1
to save all your settings
T
or
B
8.
T
or
B
9.
10.
s2
s1
s2
s1
11
11