Troubleshooting - Fujitsu L20T-1 ECO Getting Started

LCD monitor

Troubleshooting

Should an error occur, first check the following points. If the distortion is still not eliminated, the
monitor should, if possible, be checked on another computer.
If you are unable to solve the problem, please inform our help desk.
Having this problem?
No screen display
(power indicator does not light)
No screen display
(power indicator lights)
Message:
No Video Input
Or
No Signal
Message:
e.g.
This is 85 Hz overdrive.
Change computer display input
to ..... x ..... at 60 Hz.
or
Frequency out of range
Please change the display mode
to .......
Picture position not correct
8 - English
Downloaded from ManualMonitor.com Manuals
Check the following points:
Check whether the monitor is switched on.
Check whether the power cable on the monitor is
connected correctly.
Check whether the computer is switched on.
Check whether the computer is switched on.
Check whether the data cable for the monitor is
correctly attached to the monitor port on the
computer.
Press any key on the computer keyboard - the
computer may be in energy saving mode.
Alter the brightness and/or contrast until you get a
picture.
Check whether the data cable for the monitor is
correctly attached to the monitor port on the
computer.
Check whether the computer is switched on.
The input signal (horizontal frequency and refresh rate)
does not correspond to the technical monitor data.
Adjust the video frequency range using the computer
software (see documentation for your computer or
your graphics card).
Adjust a different screen resolution using the
computer software (see documentation for your
computer or your screen controller).
The monitor recognises an undefined mode.
Carry out the auto-adjustment of the monitor (with
the AUTO button - if present - or via the OSD menu).
Set the picture position with the OSD menu.
Edition 2