Table of Contents
Advertisement
PRE-INSTALLATION
PREPARATION
WARNING: A qualified installer or
service person must install stove
and burner system. Follow all local
codes.
LOCATION AND SPACE
REQUIREMENTS
Determine the safest and most efficient
location for your Buck Stove cast iron
stove. Make sure that rafters and wall
studs are not in the way of the venting
system. Choose a location where the heat
output is not affected by drafts, air
conditioning ducts, windows, or doors.
Figure 2 shows some common locations.
Read all venting information in this
manual. Be aware of all restrictions and
precautions before deciding the exact
location for your stove.
When deciding the location of your
stove, follow these rules:
1. Do not connect this stove and burner
system to a chimney flue serving a
separate solid-fuel burning fireplace
or appliance.
2. Due to high temperatures, do not
locate this stove in high traffic areas
or near furniture or draperies.
3. Proper
clearances
maintained, see Figures 3 and 4.
4. This stove is a freestanding unit
designed to set directly on the floor.
If your stove is to be installed
directly on carpeting, vinyl tile, or
any combustible material other than
wood, it must be installed on a
metal or wood panel extending the
full width and depth of the stove.
See Figure 5.
Note:
Installation
Provision for Adequate Combustion
and Ventilation Air
NOTE:
Adequate
clearances for servicing and proper
operation.
On Wall With Horizontal Termination
On Wall With Vertical Termination Through
Ceiling
Figure 2– Common Stove Locations
must
be
From Front
Figure 3– Minimum Clearances for Standard Installation
shall
make
accessibility
Figure 4– Minimum Clearance for Corner
Installation
Ceiling
42"
36"
From
back
Floor
2"
3
Corner Installation
3"
Left
Side
2"
19"
Figure 5– Stove with Burner System
Bottom Dimensions
Wall
2"
Rear
3"
Right
Side
Front
27 1/2"
Advertisement
Table of Contents
Troubleshooting
