Wiring Diagram - BuckMaster CDVB200 Owner's Operation And Installation Manual

PARTS IDENTIFICATION AND WIRING DIAGRAM
ON/OFF
SWITCH
WIRE FROM
(ON) BOTTOM
CONNECTOR
OF ON/OFF
SWITCH TO
THERMOSTAT
THERMOSTAT
11
13
Figure 44
BLACK WIRE (TO (OFF) TOP CONNECTOR
OF ON/OFF SWITCH)
MOTOR TO THERMOSTAT
MOTOR
WHITE WIRE (TO MOTOR)
15
14
12
16* NOT SHOWN
NOTE: If any of the original wire as sup-
plied with the stove must be replaced, it
must be replaced with type 16 ga., 105 C.
DATE
rating wire or its equivalent.
WARNING:
ING INSTRUCTION: THIS APPLIANCE IS
EQUIPPED WITH A THREE-PRONG
(GROUNDING) PLUG FOR YOUR PROTEC-
TION AGAINST SHOCK HAZARD AND
SHOULD BE PLUGGED DIRECTLY INTO A
PROPERLY GROUNDED THREE-PRONG
RECEPTACLE. DO NOT CUT OR REMOVE
THE GROUNDING PRONG FROM THIS
PLUG.
GREEN WIRE (GROUND)
"CAUTION:
when servicing controls. Wiring errors can cause im-
proper and dangerous operation."
"Verify proper operation after servicing."
31
M.B. NEW RELEASE
ELECTRICAL GROUND-
POWER CORD
Label all wires prior to disconnection
(6) ON/OFF/AUTO
SWITCH LOCATION