Hunter H41 Operator's Manual page 129

Note: Actual water manifolds may vary in detail from the one
pictured above. The manifold is based upon the amount of com-
ponents, or systems being fed from the manifold.
Note that the manifold is made up of an Inlet, an outlet
and valves located on each outlet. As noted the valve is
tagged with a color coded washer to allow you to deter-
mine if the line is a "Hot" water line or a "Cold water line.
A key is attached to the manifold via a lanyard that fits
valves open and closed.
DA NGER
!
You should always be aware if the valve to the water
heater is opened or closed. This should never be
closed if there is a possibility of the water heater
being energized. This could cause damage to your
water heater.
W A R N IN G
!
Leaving your boat unattended with the systems on water manifold on can sink your boat. If a leak developed
while attached to a water source, or dockside supply. This could sink your boat! Always close all valves when
leaving your boat attached to a dockside water supply while unattended!
Hunter 41 • Water Systems
As mentioned shows the valve in the open position.
Notice that the long side of the diamond shaped guide
indicates the position of the valve
gate. There is also an image of an
arrow on each valve washer that
indicates the position.
(Shown is the hot water valve in the closed position.)
nd allows you
or off the sys-
e the key simply
nd of the key
the side of the
The valve will
he water to the
on the position
Shows the valve opened, notice the key is perpendicular
. 9.7, and 9.8.
to the line.
show the
!
Shows the valve key horizontal to the line, or closed.
!
9.7
Valve
Valve key
WARN I NG
!
Fig. 9. 6
Fig. 9.7
!