Programme Sequence Indicators; Display - Miele G 8050 Operating Instructions Manual

Operation
Note:
You can now select the "Delay start" d
or "Drying" +c additional functions if
wished (see "Additional functions").
^ Press the Start/Stop button h/f.
The programme will begin. The
Start/Stop indicator light h/f and the
indicator light next to the last
programme selected will come on. The
sequence indicator light for the current
programme stage reached will also
come on.
Do not finish a programme
prematurely.
Important programme stages (e. g.
reactivating the water softener)
could be omitted.
Programme sequence
indicators
After a programme has been started,
the current stage of the programme is
indicated by the programme sequence
indicator lights.
The indicator light for the active
programme stage lights up during the
programme.
l Main wash / Rinses
+c Drying (additional function)
30

Display

The duration of the programme
selected appears in hours and minutes
in the display before the programme
begins. During the programme the time
left until the end of the programme is
displayed.
The time displayed may vary with the
same programme. This is due to the
water inlet temperature at each intake.
When a programme is selected for the
first time, the display shows an average
time for a cold water intake.
Each time a programme is run, the
electronic unit takes the water
temperature and the size of the load
into account, and calculates the time
required. This new figure is then
displayed when this programme is next
selected.