Table of Contents
Advertisement
Important:
1. The display is equipped with protective glass; however, it is best practice to never apply pressure
to the screen display area which may compromise the integrity of the display. The manufacturer's
warranty does not cover user abuse or improper installations.
2. All cables and cable covers MUST be connected and attached prior to installation on mount.
3. When routing cables through the cable entry make sure that the cables are formed in such a way
as to remove any stress on the connectors.
4. Installation shall be in accordance with the applicable parts of Chapter 8 of ANSI/NFPA70.
What's In The Box
Display
Remote (REM-0005)
Cord Cover
14 Screws (SCR-0043)
User Manual
Ambient Light Sensor
This display is equipped with an ambient light sensor which allows the display to intelligently adjust
the display's brightness based on the ambient lighting of the room or environment the display is
located in. A switch to turn the sensor on or off is located on the back of the display.
1. Ambient light sensor on: Your display's brightness will automatically dim as ambient lighting
decreases.
2. Ambient light sensor off: Your display settings will remain at full brightness even if the ambient
lighting of the room or environment changes.
Hint: Set the ambient light sensor switch to your desired setting before installing the display's rear
cover plate to avoid having to remove the display's rear cover plate to access the switch.
SET UP INSTRUCTIONS
(May not be available on all models)
Power Cord
8mm Socket Bit
5.5mm Socket Bit
Fuse Lock Down Plate
7
2014-06-13
#:220-9002-5 2015-02-24
Advertisement
Table of Contents
