Cable Seals; Installation Of The Rear Cover Plate - peerless-AV CL-42PLC68-OB User Manual

Cable Seals

1. Plug cables into proper input connection.
2. Run cable across foam gasket block.
Notes: a. If running one cable per block,
run cable over middle of cable
block.
b. If running more than one cable
on a block, ensure that cables
are at least ¼" apart to allow for
proper sealing.
3. Cables will be sealed when rear cover plate
is attached and screwed into place.

Installation Of The Rear Cover Plate

1. Place cover plate directly over cables aligning
holes with screw inserts.
2. Apply pressure to center of cover plate.
Note: Foam gasket block should
compress when pressure is applied.
3. Screw in screws until they will no longer
tighten.
Note: Do not over torque screws as
they may strip and damage the cable
seal.
4. When all screws are installed properly, the
cables should appear to be completely
encapsulated between the cable gland and
the back cover plate.
9 2014-06-13 #:220-9002-5 2015-02-24