Samsung SyncMaster 2043SW User Manual page 123

Q:
A:
Q:
A:
A:
A:
Q:
A:
A:
A:
Q:
A:
I cannot see the On Screen Display.
Q:
A:
Downloaded from ManualMonitor.com Manuals
(Connected using the DVI cable)
If you still see an error message on the screen when the monitor is connected properly,
check to see if the monitor status is set to analog.
If you still see an (error) message on the screen when the monitor is connected properly,
check to see if the monitor status is set to analog. Press '
the monitor double-check the input signal source.
If the power is on, reboot the computer to see the initial screen (the login screen), which
can be seen.
If the initial screen (the login screen) appears, boot the computer in the applicable mode
(the safe mode for Windows ME/XP/2000) and then change the frequency of the video
card.
(Refer to the Preset Timing Modes)
If the initial screen (the login screen) does not appear, contact the Service Center or
your dealer.
Can you see "Not Optimum Mode", "Recommended Mode 1920 x 1080 60 Hz" on the
screen?
You can see this message when the signal from the video card exceeds the maximum
resolution and frequency that the monitor can handle properly.
Adjust the maximum resolution and frequency that the monitor can handle properly.
If the display exceeds SXGA or 75 Hz, a "Not Optimum Mode", "Recommended
Mode 1920 x 1080 60 Hz" message is displayed. If the display exceeds 85 Hz, the
display will work properly but the "Not Optimum Mode", "Recommended Mode 1920 x
1080 60 Hz" message appears for one minute and then disappears.
Please change to the recommended mode during this one-minute period.
(The message is displayed again if the system is rebooted.)
There is no image on the screen. Is the power indicator on the monitor blinking at 1
second intervals?
The monitor is in PowerSaver mode.
Press a key on the keyboard to activate the monitor and restore the image on the screen.
If there is still no image, press the '
keyboard again to activate the monitor and restore the image on the screen.
Connected using the DVI cable?
You may get a blank screen if you boot the system before you connect the DVI cable,
or disconnect and then reconnect the DVI cable while the system is running as certain
types of graphic cards do not send out video signals. Connect the DVI cable and then
reboot the system.
Have you locked the On Screen Display (OSD) Menu to prevent changes?
Unlock the OSD by pressing the [MENU/
Troubleshooting
/SOURCE' button. Then press any key on the
] button for at least 5 seconds.
122
/SOURCE' button to have