Table of Contents
Advertisement
Initial Assembly
Your power chair may require some assembly either before initial use or after transportation. It may also requre
disassembly to make some comfort adjustments.
Euro Seat Installation (Standard)
It may be necessary to install the seat either prior to initial operation or after transporting your power chair. The
standard seat installation method incorporates four (4) adjustable seat towers located on the seat frame and four
(4) seat mount connectors located on the power base.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair
must be replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to
the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local
hardware stores or through your authorised Pride Provider.
NOTE: Pride recommends that a minimum
of two people install the seat.
NOTE: If your power chair is equipped with
a Synergy Seat or a TRU-Balance Power
Positioning System, refer to the information
provided in separate manuals.
To install the Euro Seat:
1. Remove the retaining clips from each seat
mount connector on the power base. See fig-
ure 14.
2. Lift the seat frame over the power base and
line up each seat tower with a seat mount con-
nector.
3. Slide the seat towers into the seat mount con-
nectors and secure with the retaining clips at
the desired height.
4. Route the controller cable to ensure that it
cannot be pinched in the seat frame.
5. Plug the controller connector into the elec-
tronics tray. See figure 6.
6. Secure the controller cable to the armrest re-
ceiver with one or more wire ties.
20
I V .
A S S E M B L Y
SEAT TOWER
SEAT MOUNT
CONNECTOR
Figure 14. Euro Seat Installation
www.pridemobility.com
RETAINING CLIPS
Jazzy1122
Hide quick links:
Advertisement
Table of Contents
