Bosch Gwh 260 Pn - Bosch GWH 715 ES Applications Manual

1 4 |

2.10 Bosch GWH 260 PN

Features:
Standing pilot ignition
78% thermal effi ciency
Mounts on wall for easy installation
Venting: 4" double wall B-vent — natural draft
Modulating gas valve — constant temperature at varying flow rates
Model GWH 260 PN N for natural gas (NG) supply
Model GWH 260 PN L for liquid propane (LP) supply
15-year warranty on heat exchanger
GWH 260 PN Technical Specifi cations
Gas input
Minimum fl ow to activate
Flow rates
Thermal Effi ciency
Dimensions
Weight
Modulating gas valve
Ignition
GWH 260 PN Installation Specifi cations
Gas connection
Water connections
NG gas pressure
LP gas pressure
Water pressure
(Static)
Electrical supply
Venting
Application manual | 11.2007
Natural Gas: 30,735 - 74,900 BTU
LP Gas: 30,735 - 74,900 BTU
0.6 gallons per minute (gpm)
45˚F rise @ 2.6 gpm
55˚F rise @ 2.1 gpm
65˚F rise @ 1.7 gpm
77˚F rise @ 1.5 gpm
90˚F rise @ 1.3 gpm
NG: 78% LP: 78%
28.8" h x 12.2" w x 8.5" d
25 lbs.
yes
Standing pilot
¾" Male NPT
¾" Male NPT
Minimum: 7" W.C.
Maximum: 14" W.C.
Minimum: 11" W.C.
Maximum: 14" W.C.
Minimum: 30 PSI
Minimum well pressure: 40PSI
Maximum: 150 PSI
120VAC - plugs in
4" double wall B-vent - natural
draft
GWH 260 PN Installation Clearances
Top (A) 12"
Front (B) 4"
Back 0"
Sides 4"
Floor (C) 12"
LIS TE D G AS VE NT
E S TA B LIS H A O NE
F O O T R IS E B E F O R E
A NY E LB O W S
Fig. 4 Venting confi guration
Installation guidelines:
Venting:
4" minimum diameter — do not reduce vent size.
Refer to installation manual for vent material options
Do not combination vent with any power vented appliances.
Establish a one-foot rise before any elbows
Minimum vent height - 6 feet.
Horizontal sections must slope upwards at least ¼" for every foot
of the horizontal length and be properly supported.
Gas piping:
Heater will not function properly without adequate supply gas
pressure.
Any appliance connector should be ¾" minimum diameter
Plumbing:
Install the included pressure relief valve and pipe to suitable
drain.
Minimum piping diameter is ¾".
Do not solder directly to the bottom of the unit.
Use full port ball valves for isolation valves.
BOSCH THERMOTECHNOLOGY CORPORATION
Applications manual
LIS TE D VE NT C AP
MINIMUM 6
FE E T (1.8M)