Lifescan InDuo blood glucose meter User Manual page 71

• Take the needle off the InDuo
insulin doser immediately after each
injection. If you do not remove it,
temperature changes may cause
liquid to leak out of the needle.
With an insulin suspension (cloudy
insulin), a leak of liquid may change
the concentration of the insulin.
• Do not start injecting an insulin
suspension (cloudy insulin) if the
rubber stopper is below the arrow
marks on the slide. The glass ball
must have adequate space to
resuspend the insulin. Instead, you
must replace the old PenFill
new one.
• Do not use the residual scale to
measure the amount of insulin to be
injected.
• Do not try to repair a faulty InDuo
component.
TM • The InDuo
used according to the instructions in
this manual. The manufacturer will
not be held responsible for any
equipment problems if you have not
followed the instructions.
• Healthcare professionals, relatives
and other carers should follow
general precautionary measures for
removal and disposal of needles to
minimize the risk of unintended
needle penetration.
• Keep the InDuo
® with a Ultra strips, and OneTouch
control solution at the same relative
temperature before testing. Testing
before the meter, strips, and control
solution reach the same relative
temperature may result in an
inaccurate glucose reading.
TM
IMPORTANT INFORMATION
TM system must only be
meter, OneTouch
TM
® Ultra
67
®