Rear Wheels, Adjustment - Invacare rea Spirea 2 User Manual

1.
A
6QQNU  OO HKZGF URCPPGT
24 mm fixed spanner
2.
6QQNU  OO HKZGF URCPPGT
24 mm fixed spanner
REAR WHEEL SETTINGS – CARER-OPERATED BRAKES
1.
Spirea 2

REAR WHEELS, ADJUSTMENT

1. Changing the balance
B
2. Changing the height of the drive wheel
1. Loosen both screws (A) and remove the brake
A
The rear wheel plate can be fitted in front of or
behind the frame tube. If you place the wheels in
any of the frontal positions, this will make the chair
easier to propel, but also more unstable. You can
counteract this by fitting an anti-tip device to the
chair, giving you a chair that is both easy to propel
and stable. Loosen the two attachment screws (A)
so that the attachment can be moved. To achieve
the lowest or highest seat height, you must turn
the plate upside down (B).
The tip risk increases if the rear wheel are
located in front of the backrest.
attachment.
The illustrations show quick-release rear wheels,
but the procedure is the same for fixed hubs.
Loosen the axle housing with a fixed key. Remove
the casing and place in a different position. For
different positions, see page 17.
When you have fitted the wheels in the correct
position, it is important that you check thor-
oughly that the nuts and screws are tightened
securely. The axle housing should be tightened
with a manual and dynamometric wrench cali-
brated to 40Nm. This is important for your
own safety!
handle.
17