Repositioning The Cooker Following Connection; Conversion To Another Gas; Levelling - Rangemaster Professional Deluxe 110 User's Manual & Installation Instructions

INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
Repositioning the Cooker Following
Stability bracket
Fig.7-9
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
Cooker
fascia panel and lifted the front of the cooker slightly
(Fig.7-6); you need to check behind the cooker to make sure
that the gas hose is not caught.
3 mm min
As you progress, make sure that both the electricity cable and
Floor
gas hose always have su cient slack to allow the cooker to
ArtNo.070-0014 - Stability bracket - Wall fitting
move.
Typical oor mounting
With a stability chain tted, release it as you ease the cooker out.
Do not forget to re t it when you replace the cooker.
Fig.7-10
Outer stability
When you replace the cooker, again check behind to make
bracket
sure that the electricity cable and gas hose are not caught or
trapped.
Cooker

Conversion to Another Gas

If the appliance is to be converted to another gas do the
conversion at this point. See the conversion section of these
3 mm min
instructions and see the instructions in the conversion kit.
Wall
Floor

Levelling

You are recommended to use a spirit level on a shelf in one of Typical wall mounting
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front, turn the feet bases to raise or lower.
29