Horizon Fitness Andes 208 Assembly Manual page 4

ASSEMBLY STEP 4
HARDWARE BAG FOR STEP 4 CONTENTS :
NUT (G) TEFLON WASHER (H)
M10 25 mm
Qty: 2 Qty: 4
ASSEMBLY STEP 5
HARDWARE BAG FOR STEP 5 CONTENTS :
A) Open HARDWARE BAG FOR
STEP 4.
B) Place TEFLON WASHER (H) over
CRANK ARM followed by
PEDALARM.
C) Place a second TEFLONWASHER
(H) over PEDAL ARM and attach
usingNUT (G).
D) Repeat on other side.
E) Attach PEDAL ARM COVERS
toPEDAL ARMS using SCREWS (I).
SCREW (I)
25 mm
Qty: 2
A) Open HARDWARE BAG FOR
STEP 5.
B) Remove PRE-ATTACHED BOLT &
WASHERS from CONSOLE MAST.
C) Slide UPPER HANDLEBARS onto
CONSOLE MAST and attach by
re-insertingPRE-ATTACHED BOLT
And one Arc Washer And one Pre-Spring.
D) Attach LOWER HANDLEBARS to
UPPER HANDLEBARS using PRE-
ATTACHED SCREWS.
E) Attach HANDLEBAR COVERS
using4 SCREWS (J).
5
ASSEMBLY STEP 6
PEDAL ARM
FOOT PAD
WAVY WASHER (L)
A) Open HARDWARE BAG FOR STEP 6.
B)Slide WASHER(L) And WAVY WASHER (K) and the Rocker-Arm onto the PEDAL
ARM axle.
C) Attach Them Using Washer And BOLT(M) .
D)Repeat on other side.
HARDWARE BAG FOR STEP 6 CONTENTS :
BOLT (M)
12 mm
Qty: 2
WASHER
28.7mm
QTY:2
6
WAVY
WASHER (L)
Qty: 2
WASHER
25mm
QTY:2