Pioneer AVIC-X9310BT Operation Manual page 396

Chapter
26 Customizing preferences
Display the "Audio Menu" screen.
1
= For details, refer to Displaying the
"Audio Menu" screen on page 126.
2 Turn MULTI-CONTROL to select
"P.EQ Setting1".
3 Press MULTI-CONTROL left or right to
select the equalizer band to adjust.
Each time MULTI-CONTROL is pressed left or
right, the equalization band is selected in the
following order:
Low — Mid — High
4 Press MULTI-CONTROL up or down to
adjust the level of the equalizer band.
Each time MULTI-CONTROL is pressed up or
down, the level of the equalization band in-
creases or decreases. "+6" to "–6" is displayed
as the level is increased or decreased.
5 Turn MULTI-CONTROL to select
"P.EQ Setting2".
6 Press MULTI-CONTROL left or right to
select the desired frequency.
Press MULTI-CONTROL left or right until the
desired frequency appears in the display.
Low: 40 Hz — 80 Hz — 100 Hz — 160 Hz
Mid: 200 Hz — 500 Hz — 1 kHz — 2 kHz
High: 3 kHz — 8 kHz — 10 kHz — 12 kHz
7 Press MULTI-CONTROL up or down to
select the desired Q factor.
Press MULTI-CONTROL up or down until the
desired Q factor appears in the display.
2W — 1W — 1N — 2N
8 Repeat above adjustments.
If necessary, you can adjust other equalization
bands successively.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
Display the "Audio Menu" screen.
1
= For details, refer to Displaying the
"Audio Menu" screen on page 126.
Turn MULTI-CONTROL to select "Loud-
2
ness".
128
En
3 Press the center of MULTI-CONTROL to
turn loudness on.
Loudness level (e.g., Mid) appears in the dis-
play.
p To turn loudness off, press
MULTI-CONTROL again.
4 Press MULTI-CONTROL left or right to
select a desired level.
Each time MULTI-CONTROL is pressed left or
right, level is selected in the following order:
Low — Mid — High
Using subwoofer output
The navigation system is equipped with a sub-
woofer output mechanism, which can be
turned on or off.
Display the "Audio Menu" screen.
1
= For details, refer to Displaying the
"Audio Menu" screen on page 126.
Turn MULTI-CONTROL to select "Sub-
2
Woofer1".
3 Press the center of MULTI-CONTROL to
turn subwoofer output on.
p To turn subwoofer output off, press
MULTI-CONTROL again.
4 Press MULTI-CONTROL left or right to
set the phase of subwoofer output.
Each time MULTI-CONTROL is pressed left or
right, the phase of subwoofer output is se-
lected in the following order:
Reverse (Reverse phase) — Normal (Normal
phase)
Turn MULTI-CONTROL to select "Sub-
5
Woofer2".
6 Press MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pressed left or
right, frequencies are selected in the following
order:
50 Hz — 63 Hz — 80 Hz — 100 Hz — 125 Hz