Pioneer AVIC-X9310BT Operation Manual page 198

Appendix
Appendix
Messages and how to react to them
The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Messages for navigation functions
Message
Route calculation was not
possible.
Route calculation not possi-
ble: destination is too far.
Route calculation not possi-
ble: destination is too close.
Route calculation not possi-
ble: navigation cannot be pro-
vided around destination or
starting point.
Route to destination cannot
be calculated.
Failed to make the route pro-
file.
No picture folder. Save jpeg
file to /Pictures/ folder
Data Read error.
The file is corrupt
198
En
Cause
Route calculation has failed be-
cause of a malfunction in map data,
software, or hardware.
The destination is too far.
The destination is too close.
The destination, waypoint(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible.
The destination or waypoint(s) are in
an isolated island, etc. without a
ferry and the route calculation is im-
possible. If there is no road con-
nected to your starting point or
destination, this message will ap-
pear.
In rare cases, a route calculation
error may occur.
Cannot load the image because
"Pictures" folder is not found in the
inserted external storage device.
"Pictures" folder exists on the SD
memory card but there is no load-
able data in the folder.
Failed to read the data for some rea-
son.
The data is damaged or an attempt
was made to set an image file that
was not made to specifications as
the splash screen.
Action (Reference)
! Change the destination.
! Consult the Pioneer Local dealer if this mes-
sage persists.
Set a destination closer to the starting point.
Set a destination farther from the starting
point.
! Set a destination and waypoint(s) on roads.
! Reset the destination after you drive the ve-
hicle to any road.
Change the destination.
! Retry.
! Consult the Pioneer Local dealer if this mes-
sage persists.
Use appropriate data and store it correctly.
(Page 165)
Use appropriate data and store it correctly.
(Page 165)
Use appropriate data and store it correctly.
(Page 165)
Use appropriate data and store it correctly.
(Page 165)