Button Sewing - Janome 3022 Instruction Manual

Janome 3022 Instruction Manual
e
z x
c v b
www.aaasewing.com
q w

Button Sewing

Machine Settings
q Pattern:
#08
w Presser foot:
Satin stitch foot F
e Feed dog:
Down
z Unthread the needle thread.
Adjust the stitch width so that the needle enters
both holes in the button.
x Place a button on the fabric and lower the needle
by turning the handwheel, so that the needle enters
into the left hole in the button.
Align the holes in the button with the slot on the
foot and lower it to hold the button in place.
c Turn the handwheel to lower the needle into the
right hole in the button.
Adjust the stitch width if necessary.
Rethread the machine and sew about 10 stitches at
a slow speed (set the speed control slider at
v Raise the presser foot and remove the fabric.
Trim both needle and bobbin threads at the
beginning.
Cut both threads leaving 20 cm (8˝) tails.
b Pull the bobbin thread to bring the needle thread to
the wrong side of the fabric then knot the threads.
After sewing is finished, raise the feed dog.
54
).
3022 Owners Manual/ User Guide