Troubleshooting - Kärcher BRC 30/15 C Operating Instructions Manual

PROBLEM
No power, nothing runs.
Vacuum motor will not run.
Vacuum motor runs but
suction is poor.
Poor or no water flow.
(carpet is streaky)
Brush does not spin.
Accessory tool fitting difficult
to connect
CAUSE
Is the cord plugged in.
Circuit breaker tripped in building.
Faulty switch.
Faulty power cord or pigtail.
Vacuum circuit breaker tripped.
Faulty main switch.
Loose wiring.
Faulty vac motor.
Debris lodged in vac shoe.
Dome gasket defective or missing.
Vacuum hose cracked or hose cuff loose
Recovery tank full.
Switch to accessory mode.
Jets clogged or missing.
Solution filter clogged.
Faulty solution pump.
Switch in accessory mode.
Brush circuit breaker tripped.
Brush belt broken.
Faulty brush motor.
Corrosion on fitting.
86348550 BRC 30/15 C
Maintenance

Troubleshooting

SOLUTION
Plug in cord.
Reset breaker.
Call for service.
Call for service.
Reset breaker.
Call for service.
Call for service.
Call for service.
Remove debris from vac shoe.
Replace as necessary.
Replace or repair as necessary.
Turn off vac motor. Drain and rinsere-
covery tank.
Turn to deep clean position.
Jets clogged or missing.
Drain solution tank and clean solution-
filter.
Call for service.
Turn to deep clean position.
Reset circuit breaker.
Replace as necessary.
Call for service.
Clean with steel wool. Remove and soak
in acetic acid (white vinegar). Lubricate
lightly with silicone base lubricant.
21