Pittasoft BLACKVUE LCD User Manual page 40

Time Setting
If an external GPS is not connected, set time manually before use.
If time is not set, the time of a recorded video may not be correctly saved.
1
Format the microSD card, and then upgrade the firmware.
2
Connect to the website of BlackVue (www.blackvue.com), and download
the time setting program.
3
Run the time setting program before setting time.
Note
y When setting time, set time when BlackVue power is on. The product
boots approximately 15 seconds after power supply.
y If an external GPS is connected, time will be automatically set.
40
Sensitivity Setting
In recording mode, the G-sensor sensitivity(impact sensitivity) and motion detection
sensitivity can be set for each start event recording. The speed alert can be set to
start event recording when vehicle exceeds the set speed level.
1
Click the button and click the
2
Change a setting, and click Save &
Note
y For details about advanced sensitivity settings, refer to
Sensitivity Settings. (Page 42)
Sensitivity tab.
Close.
Advanced